Filter
Top Products
20
Aurorean Network Gateway-1000 User’s Guide
Chapter 3
Configuring the ANG-1000 with Aurorean Web Config
NOTE
If you press the reset button after you have configured your ANG-1000,
you will lose your entire configuration. Any settings you supplied must
then be re-entered. We strongly recommend that you do not use the reset
button unless you want the configuration to return to factory defaults.
Setting Up the Internet Connection
Internet configuration of the External side of the ANG-1000 involves choosing
the type of IP address assignment the ANG-1000 will accept. The ANG can
accept one of the following:
H A DHCP-assigned IP address - your network automatically sets the
ANG’s IP address via the DHCP (Dynamic Host Configuration
Protocol) server.
H A Manual-assigned IP address - you or your network administrator
set the ANG’s IP address and associated Subnet, Gateway, and DNS
values. Consult with your Network Administrator for required
values.
H A PPPoE (PPP over Ethernet) assigned IP address - your DSL
provider transparently sets the IP address via the use of a Username
and Password. Obtain this information from your service provider
before you enter this data.
Begin Internet Setup by performing the following steps: