Filter
Top Products
28
Aurorean Network Gateway-1000 User’s Guide
Chapter 3
Configuring the ANG-1000 with Aurorean Web Config
Checking Device Status
The Device Status window provides a host of important data to ensure the
ANG-1000 is connected properly and to permit troubleshooting as problems
occur. When consulting Enterasys Customer Support, you will be asked to
display this window.
The following categories are detailed in the Device Status window:
H Version lists the Release, Patch and Build numbers, and internal name
of the ANG-1000’s firmware.
H CPU itemizes Motorola Coldfire chip specifications.
H Memory enumerates ANG-1000 memory values including Total,
Used, Free, Shared, Cached, Buffered and Swapped bytes.
H Interface Configuration describes Trusted (eth0), External (eth1), IPsec
(eth1:0-24), PPTP (ppp0-24) and Local Loopback (lo) port data
including IP and MAC addresses, netmasks, Receive and Transmit
errors and other information. Note that the ppp0 interface is the
Internet, not WAN interface, if the Internet is configured for PPPoE.
H Network Devices tabulates interface Receive and Transmit errors.
H Route Table entries detail connected networks, gateways, their
associated IP addresses, netmasks and other data.
H Interrupts lists the hardware interrupts supported on the ANG-1000
as well as their vectors and interrupt counters. The two SMC9194
items listed are the Ethernet Trusted and External port interrupts.
H System Log categorizes ANG-1000 functions/malfunctions including
routing connections/disconnections.
Check Device Status by performing the following step:
1 Click the Device Status menu option.
The Device Status window appears as shown in Figure 25.