Filter
Top Products
2-5
Overview of Connecting Cables to the RoamAbout R2
2. Remove the plastic cap from the PC Card(s) and connect the pigtail cable. After the
Lightning Protector has been installed and grounded, connect the other end of the
pigtail cable to the Lightning Protector.
3. Connect the Ethernet cable from the RoamAbout R2 to the RoamAbout R2 connector
on the power adapter.
4. Record the RoamAbout R2’s MAC address (located on the side of the unit). You need
this address when configuring the RoamAbout R2 from the AP Manager program.
5. If using the remote power option, connect the power adapter to the power connector
on the remote power adapter. Do NOT connect the power adapter to the power source
at this time.
6. If using the remote power option, connect the Ethernet cable from the site network to
the Ethernet connector on the remote power adapter.
7. Optionally, snap on the security cover.
8. Connect the power adapter to the power source.
NOTE: If you are not using the remote power option, connect the network
and power cables directly to the RoamAbout R2.
NOTE