Filter
Top Products
PowerLite 1810p/1815p
3/08 PowerLite 1810p/1815p - 25
Replacing the Lamp and Air Filter
The life span of the projection lamp is about 2,500 hours if
Brightness Control in the Settings menu is set to High
(default), and 3,000 hours if
Brightness Control is set to Low.
It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The message
Replace the lamp appears on the screen when
the lamp comes on and the lamp warning light flashes
orange. To maintain projector brightness and image quality,
replace the lamp as soon as possible.
❏ The lamp warning light flashes red (the lamp is burnt
out).
Follow these steps to replace the lamp and air filter:
1. Turn off the projector and unplug the power cord.
2. Let the projector cool for at least an hour (if it has been on).
The lamp is extremely hot immediately after use.
3. Loosen the lamp cover screw (you don’t need to remove it).
Then slide the lamp cover to the side and lift it off the
projector.
4. Loosen the two screws holding the lamp in place (you can’t
remove them).
5. Hold the lamp as shown and pull it straight out.
6. Gently insert the new lamp. (If it doesn’t fit easily, make sure
it is facing the right way.)
7. Once the lamp is fully inserted, tighten its screws.
8. Replace the lamp cover, then tighten its screw.
9. Slide out the air filter on the bottom of the projector and
remove it.
10.Slide in the new air filter until it clicks in place.
11.Reset the lamp timer as described in the next section.
Note: When you get a replacement lamp for your projector, you
should replace the filter. Turn off this product when not in use to
prolong the life of the projector.
Lamp
warning
light
Loosen, but don’t
remove these screws