Filter
Top Products
151
Maintaining and Transporting the Printer | 151
3. Select one of the following, then press OK:
• ON: PERIODICALLY—The printer periodically checks its nozzles
and runs a cleaning cycle if necessary (default).
• ON: EVERY JOB—The printer automatically checks its nozzles
and runs a cleaning cycle if necessary before each print job. This
process uses a very small amount of ink (and no paper) and is
recommended if you are running large print jobs unattended.
•OFF—The printer will not perform automatic nozzle checks and
cleaning cycles.
4. Press
l, then select PRINT NOZZLE PATTERN and press r.
5. Select
ON: EVERY PAGE to have the nozzle check pattern printed
before each print job, or
ON: EVERY 10 PAGES or OFF. These settings
take effect only when you print on roll paper.
6. Press
OK to save the setting.
Running Cleaning Cycles
You can run several types of cleaning cycles from the control panel (or from
the Epson LFP Remote Panel2): normal cleaning, power cleaning, and
cleaning each pair of ink colors.
Run the power cleaning only if the normal cleaning process is not sufficient
to clear the nozzles. The power cycle uses a large quantity of ink, so it is
recommended only as a last resort.
The cartridges need to be at least 50% full to use power cleaning. You may
need to replace a low cartridge to run the cleaning cycle. After cleaning, you
can reinsert the old cartridge.
1. Print a nozzle check to make sure the print head needs cleaning, as
described on page 150.
2. Make sure the printer is ready and the red B ink
Check light on the
printer’s control panel is not on or flashing.
3. Press r
Menu.
Caution: Don’t run a
cleaning cycle while
thick media is loaded in
the printer.