Filter
Top Products
Using Continuous Paper
3. Slide the left sprocket unit to approximately 0.5 inches (12 mm)
from the far left position and push the lever back to lock it in
place. Then slide the right sprocket unit to match the width of
your paper, but do not lock it.
4
5
Position the paper support midway between the two sprocket
units. Open both sprocket covers.
Make sure your paper has a clean, straight edge. Then insert the
paper into the desired paper slot (rear or bottom) until it
emerges between the platen and the ribbon guide. Pull the paper
up to the sprocket units.
6.
Fit the holes of the paper over the tractor pins of the sprocket
units, and then close the sprocket covers.
Paper Handling 2-9