Filter
Top Products
FCC Compliance Statement for United States Users
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference in which case the user will be required to correct the interface
at his own expense.
This devise complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels which
exceed the limits established by the FCC for this equipment. It is the responsibility of the
user to obtain and use a shielded equipment interface cable with this device. When this
equipment is attached to some printers, you should not leave cables connected to the
printer’s built-m connectors. See your printer’s user’s manual for details.
Changes or modifications not expressly approved by Seiko Epson Corporation could void
the user’s authority to operate the equipment.
for Canadian Users
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus as set out in the radio interference regulations of the Canadian
Department of Communications.
Le
present
appareil
numerique
n’emet
pas
de
bruits
radioelectriques
dgpassant les
limites
applicables aux appareils num6riques de
Classe
A
prescrites
dans
le reglement sur le
brouillage
radioelectrique
edict6
par le Ministere
des
Communications
du
Canada.
iii