If normal operation is suspended for any reason, the Ethernet Card
enters an error state (red and green status lights are lit). To obtain
a printout describing the error, press the
Status Sheet/Error
Resume
button once. After printing the report, the card returns to
its normal operating mode (green status light is lit).
Note:
if the status sheet does not print, first make sure that the printer is on
line. If it is on line but the status sheet still does not print, you will have
to reset the
printer
by turning it off and back on. After turning off the
power, wait at leastfive seconds
before
turning it back on; otherwise you
may damage the printer.
Report printing is available after the printer is turned on and has
completed its initialization routine. The Status Sheet/Error
Resume function is not available under the following conditions:
Cl
The printer is off line or not ready
Cl
The printer has started printing
Under normal operating conditions, the status sheet will print in
one of the following emulation
modes:
ESC/P*-**, ESC/Page, PCL
(LJ-2P, 3/P/Si, LJ-4P), GL (HP-GL, HP-GL2, EP-GL), PostScript
(EpsonScript), PR-201, GQ.
Using the EPSON PostScript card
If your printer has an EpsonScript (PostScript) card installed, allow
about a minute for the printer to initialize before trying to install
or configure the Ethernet Card on the network. The Ethernet Card
may not respond if initialization has not been completed.
Network installation
See the appropriate chapter in this guide for instructions on
installing the card on a specific network.
1-6
Installing the Ethernet Card