Filter
Top Products
Memory Module Problems
The memory count displayed by the power-on diagnostics
program is incorrect
You may have installed the SIMMs incorrectly. They may be
the wrong type or speed, or they may not be inserted all the
way. See Chapter 3 for information on installing SIMMs.
Controller Problems
You see a controller error for the hard disk drive controller,
the video controller, or the i/O port controllers when you
start your system.
The indicated controller on your system board may be faulty.
If you have an option card with a controller that will work with
your device, you can install it and change the jumper settings
on the system board to disable the built-in controller. You can
then continue to use your system until it is convenient for you
to have it serviced.
Mouse Problems
Your mouse isn't working properly or you see an auxiliary
device error message.
Make sure the mouse cable is securely connected to one of the
serial ports. Also make sure you installed the mouse driver
correctly. See the documentation that came with your mouse
and Chapter 1 for instructions.
Check jumpers J2, J3, J8, and J10 to make sure they are set
correctly.
Troubleshooting 6-11