Epson EMP-S1H Projector User Manual


 
58
Appendices > Projector Care
C
Loosen the fixing screws holding the lamp in place.
D
Remove the old lamp.
E
Install the new lamp.
Press the lamp until it clicks into place, then tighten the two fixing
screws.
F
Replace the lamp cover.
First insert the tabs, and then press down on the opposite side until it
clicks into place.
p
Install the lamp securely. If the lamp cover is removed, the
lamp turns off automatically as a safety precaution. The
lamp will not turn on if the lamp or the lamp cover is not
installed correctly.
After replacing the lamp, be sure to reset the lamp
operating time.
New air filters are included with replacement lamps. The
air filter should also be replaced when the lamp is replaced.
s "Lamp replacement period" P.57
The lamp contains mercury. Dispose of used lamps
properly in accordance with your local regulations.