Filter
Top Products
52
Appendix
You can check the status of this unit using the indicators on the top
panel.
Check each condition in the following table and follow the steps
to remedy the problem.
* If all indicators are switched off, check that the power cable is
connected correctly and whether or not the main power switch
is turned on.
Troubleshooting
When flashes green / orange alternately Error
: flashing green/orange alternately
: lit : flashing : off
Internal error
Turn the main power switch off then on. If
the indicator status does not change once
has been pressed and the power
switched on
Fan related error/Sensor error
High temperature error
(overheating)
The lamp turns off automatically and
projection stops. After being in this state
for around 40 seconds and then entering
stand-by mode, check the 2 items listed
to the right.
If the power was turned off, turn the main
power switch back on again.
• Move this unit away from
the wall by at least 20 cm.
• Clean the air filter.
s page 56
If the indicator status
does not change
once has been
pressed and the
power turned on
Lamp error/Lamp fails to light up/Lamp cuts out /Lamp cover open
Check if the lamp is broken. s page 58
The lamp is not broken
Reinsert the lamp then turn on the main power
switch on the main unit and press .
If the condition is not
fixed once the lamp
is re-inserted
The lamp is broken
Contact your dealer. s page 65
Reading the indicators
Red
Red
Disconnect the power cable from the electrical
outlet and contact your dealer.
s page 65
Red
Red
Red