Filter
Top Products
56
This section describes maintenance tasks such as cleaning the projector and replacing consumable parts.
Cleaning the air filter
When dust builds up on the air filter, or the message
"The projector is overheating. Make sure nothing is
blocking the air vents, and clean or replace the air filter"
is displayed, remove any dust from the air filter using a
vaccum cleaner.
Cleaning the main unit
Cleaning the projection lens
Maintenance
cCaution:
If dust collects on the air filter, it can cause the internal
temperature of the projector to rise, and this can lead to
problems with operation and shortening of the optical
engine’s service life. It is recommended that you clean these
parts at least once every three months. Clean them more
often than this if using the projector in particularly dusty
environments.
Clean the surface by wiping it gently with a soft cloth.
If the projector is particularly dirty, moisten the cloth
with water containing a small amount of neutral
detergent, and then firmly wring the cloth dry before
using it to wipe the projector’s surface. Then wipe it
again with a soft, dry cloth.
cCaution:
Do not use volatile substances such as wax, alcohol, or thinner
to clean the projector's surface. These can cause the projector
to warp and make the coating finish peel off.
Use a commercially available air blower, or use a lens
cleaning paper to gently wipe the lens.
cCaution:
Do not rub the lens with harsh materials or subject the lens to
shocks, as it can easily become damaged.
Cleaning