Filter
Top Products
55
Appendix
When using external video modes
At these times Check here.
Reference
page
No images appear • Is the power for the connected equipment turned on?
Switch on the power to the connected equipment, or start playback
depending on the playback method for the connected equipment.
s page 38
• When signals have been connected to both the S-Video input port and
the Video input port, only the S-Video signal is available. If you want
to watch the image from the equipment connected to the Video input
port, disconnect the cable from the S-Video input port.
-
"Signal not supported" is
displayed
If you cannot project even when the "Video Signal" is set to "Auto" in
the Information menu, set to the signal format appropriate to the
equipment.
s page 51
"No signal." is displayed • Are the cables connected correctly? s page 37, 38
• Is the power to the connected equipment turned on ?
Switch on the power to the connected equipment, or start playback
depending on the playback method for the connected equipment.
s page 38
• Press to switch to DVD.
s page 38
The signal is distorted If an extension cable is used, electrical interference may affect the
signals. Connect amplification equipment and check.
-
Image is truncated (large) or
small
The unit automatically recognizes and projects the aspect ratio for the
input signal. If the aspect ratio is not projected correctly, press
and select the aspect ratio appropriate to the input signal.
-
Image colors are not right In the Information menu, set the "Video Signal" to the signal format
appropriate to the equipment.
s page 51