Filter
Top Products
22 Using the Projector Menus
Video Menu (Video Image Source)
The Video menu lets you make adjustments to the projected
image. The following options are available when the image
source is Video.
note
The projector’s image
source must be set to
Video, and the video
source (such as a VCR or
camcorder) must be
connected and operating
f
or you to access these
menu options. For
example, the projector
must actually be
p
rojecting the image from
y
our video tape if you’re
using a VCR.
Menu item Description
Position Use the Enter button to move the screen
position in the corresponding direction.
When you finish making adjustments, press the
Esc button.
Brightness Lightens or darkens the overall image. Increase
brightness to lighten an image, or decrease it to
darken the image.
Contrast Adjusts the degree of difference between light
and dark areas. Increase the contrast to make
light areas lighter and dark areas darker.
Decrease it to minimize the difference between
the lightest and darkest areas of the image.
Color Adjusts color density. Increase the setting for
darker and more opaque colors. Decrease it for
lighter and less opaque colors.
Tint
(NTSC only)
Adjusts the red-green color balance of the
screen. Increase tint to add more green, or
decrease it to add more red.
Sharpness Adjusts the sharpness of the screen image.
Gamma Adjusts the projected image for natural
coloration.
Mode Specifies the image signal mode: Auto, NTSC,
NTSC4.43, PAL, M-PAL, N-PAL, PAL 60,
SECAM.
Reset Returns all menu items to their initial factory
defaults.
appendix.book Page 22 Tuesday, December 14, 1999 4:08 PM