Filter
Top Products
1 • Setting Up the Projector
50
You can connect the projector to an S-Video source, a composite video
source, and a component video source at the same time. However, the
projector automatically selects the S-Video as the video source. To
display composite or component video, first disconnect the S-Video
source.
The projector supports NTSC, PAL, and SECAM video formats, and
automatically detects and identifies the video format. However, you
can specify that a single broadcast format be detected. (See Chapter 3.)
Note that the projector will then be able to detect only one type of
video signal.
The type of cable you use to connect the video source to the projector
depends on whether you have composite video, S-Video, or
component video. For composite video, use the audio/video (A/V)
cable supplied with the projector. For S-Video, use the S-Video cable
supplied with your video device or obtain one from your computer or
video equipment dealer. For component video, use the BNC type
cable that came with your video source. The illustration below shows
the S-Video, component, and composite connectors.
4
2
3
1
S-Video
4-pin, mini-DIN
component
BNC connector
composite
RCA
5300.book Page 50 Tuesday, April 13, 1999 4:19 PM