Filter
Top Products
Displaying and Adjusting the Image
39
2. Press the red
Power
button on the control panel. You can also use
the
Power
button on the remote control, but make sure batteries
are installed and the remote control is turned on first. (For details,
see page 50.)
The projector’s power light flashes green as the projector warms
up, and the projection lamp comes on in about 30 seconds. (To
turn off the lamp, see page 47.)
Selecting the Image Source
The screen you see when turning on the projector depends on which
image source was selected when the projector was last used. If
EasyMP.net was selected, you see the EasyMP.net main screen, as
shown below; if a computer or video source was selected, you see a
blue screen with the No Signal message.
If necessary, follow these steps to display the correct image:
1. If you’re presenting from a computer or video device, turn on the
device. (If you’re projecting a video, press
Play
on the video
device.)
2. If you’ve connected a computer that’s running Windows and it
displays a New Hardware Found message saying that it has found
a plug-and-play monitor, click
Cancel
.
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
Power
Video
Comp/
A/V mute
Resize
Esc
Help
Menu
Shift
Keystone
Volume
S
y
n
c
.
S
y
n
c
.
T
r
a
c
k
i
n
g
T
r
a
c
k
i
n
g
Power button
remote control
on/off switch
warning
Never look into the lens when
the lamp is on. This can
damage your eyes.
No Signal