Filter
Top Products
14
Adjusting the Image Quality
Adjusting Computer Images and RGB Video Images
Automatic setup detects analog RGB signals coming from a connected
computer, and automatically adjusts these signals so that the optimum
images can be obtained.
Automatic setup involves adjustment of the following three items:
Trackingg, Position, and Sync (synchronisation)g.
If “Auto Setup” in the “Signal” menu is set to “OFF,” automatic setup is
not carried out. In this case, press the [Auto] button on the remote control
or the [Enter] button on the projector’s control panel to make the
adjustment while computer or RGB video images are being projected.
If vertical stripes appear in the projected
computer or RGB video images, and this cannot
be fixed using automatic setup, you will need to
adjust the Trackingg manually using the
following procedure.
PROCEDURE
A
Select “Signal” from the configuration menu, and
then select “Tracking.”
For details on this operation, refer to
“Using the Configuration
Menu.” sp.34
Check the buttons you can use and the operations they perform
in the guide at the bottom of the screen.
Automatic Setup
•If you press the [Auto] button on the remote control, or
the [Enter] button on the control panel, while
performing other functions such as E-zoom or Freeze,
these functions are canceled and then the automatic
setup adjustment is made.
•Sometimes the signals may not be adjusted correctly
depending on the type of computer or RGB video
signals being input. In such cases, use the
configuration menu commands to adjust the tracking
and sync settings manually. sp.15
Remote control
Control panel
Adjusting the Tracking
Remote control
Control panel