Filter
Top Products
62
Maintenance
PROCEDURE
A
After you turn off the projector’s power, and the
confirmation buzzer beeps twice, disconnect the
power cable.
B
Wait until the lamp has cooled down, then remove the
lamp cover from the base of the projector.
Loosen the lamp cover screw with the screwdriver that is
supplied with the spare lamp (or your own cross head [Phillips]
screwdriver).
Then slide the lamp cover straight forward and lift it to remove.
C
Loosen the two lamp screws.
Loosen the two lamp screws with the screwdriver that is
supplied with the spare lamp (or your own cross head [Phillips]
screwdriver).
D
Take out the lamp.
Hold the lamp as shown in the illustration below and lift it up
and out of the projector.
If the lamp is broken, replace it with a new lamp, or contact
your local dealer for further advice. If replacing the lamp
yourself, be careful to avoid pieces of broken glass.