Filter
Top Products
EPSON PowerLite TW100 Projector
11/02 EPSON PowerLite TW100 Projector - 15
4. Use a screwdriver to slide the latch and pop open the lamp
cover. Then lift it up and remove it.
5. Use a screwdriver to loosen the two silver screws holding the
lamp in place. (You can’t remove these screws.)
6. Grasp the lamp as shown, and pull it straight out.
Caution: Do not touch the glass portion of the lamp assembly.
7. Gently insert the new lamp and tighten its screws.
8. To replace the lamp cover, insert the tabs and then snap the
cover into place. (The projector won’t come on if the lamp
cover is loose.)
9. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you install a new lamp, you need to reset the timer so the
projector can keep track of how many hours it has been used.
Follow these steps:
1. Press the
Menu button on the control panel or the remote
control. You see the main menu.
2. Select the
About menu. You see the lamp usage hours and
other settings.
3. Select
Reset Lamp Timer. You see this prompt:
4. Select
Yes, then press Select.
5. When you’re finished, press
Esc or Menu.
The lamp usage timer doesn’t register until you’ve used the
lamp for at least 10 hours.