Filter
Top Products
EPSON PowerLite TW100 Projector
8 - EPSON PowerLite TW100 Projector 11/02
Switching Between Picture Sources
If the projector is connected to more than one video source, you
can use the buttons on the control panel or remote control to
switch between the different sources.
On the projector’s control panel, press the
Source button to
display the currently selected source. Press it again quickly to
switch. Continue pressing the button until the name of the
source you want is displayed on the screen.
.
On the remote control, press one of the Input buttons to select
the desired source:
After you select a source, the screen goes dark for a moment
before the image appears.
Adjusting the Image
There are many ways to adjust the image once it is displayed, as
described in the following sections.
Adjusting the Height of the Image
The projector should be as perpendicular to the screen as
possible. If the image is too low, you can raise it by extending
the projector’s front foot.
1. Stand behind the projector. Press the foot release button and
lift the front of the projector. This unlocks the foot.
2. Once the image is positioned where you want it, release the
button to lock the foot in place.
3. If you need to straighten the image, rotate the round
adjustable foot at the back of the projector.
If the image is no longer square after raising it, see page 9.
Press this button
To select the source connected to
this port
S-Video S-Video
Video Composite video
A Input A component video
B Input B component video or computer
D-RGB D-RGB DVI-I port (digital cable)
A-RGB A-RGB DVI port (analog cable)
Input
buttons
Source
button
Foot release button