Filter
Top Products
l Place the printer or printer stand on a solid and level foundation.
Avoid setting it on carpet or on unstable surfaces such as chairs.
l Use a grounded outlet-one that has three holes to match the power
plug on the printer. Don’t use an adapter plug.
l
Avoid using electrical outlets that are controlled by wall switches. If
you accidentally turn off a switch, you could wipe out valuable
information and stop your printing.
l
Keep your printer and computer away from base units for cordless
telephones.
l
Avoid using an outlet on the same circuit breaker with large
electrical machines or appliances that might disrupt the flow of
power to your printer.
l Choose a place that is clean and away from moisture, dust, and
excessive heat (such as a heater or direct sunlight).
If you are going to use continuous-feed paper, clear enough space
around the printer so that the paper has an unobstructed path in and
out of the printer. There are three common methods of arranging a
printer and continuous paper:
l Using a printer stand with the paper stacked underneath it.
l Using a desk or table as a stand, with the printer near the rear edge
and the paper on the floor or on a shelf.
l Putting the printer on a desk or table and stacking the paper behind
the printer.
3 Installing the Ribbon
To install the ribbon, follow the directions below:
1. Remove the tractor cover that comes installed on the printer. To
remove it, simply pull the back of the cover toward you until the
cover is vertical. Then lift it up and off the printer.
2. Manually move the print head to the middle of the platen.
Setting Up Your FX Printer
1-3