Filter
Top Products
ESC EM
Turn Automatic Sheet Feed Mode On/Off
Format:
ASCII code:
ESC EM n
Decimal:
27 25 n
Hexadecimal: 1B
19
n
Comments:
The following values can be used for n:
4: Mode is turned ON.
0: Mode is turned OFF.
The variables are the characters “0” (48 decimal or 30 hex) and “4”
(52 decimal or 34 hex). Do not use 1 decimal, 01 hex, 4 decimal, or
04
hex.
The command should not be used unless the automatic sheet feeder
is installed. It is ignored if any value other than “0” or “4” is used for
n. The command overrides the setting of DIP switch 2-2.
MSB control
Note: MSB is the Most Significant Bit. MSB control (ESC = ,
ESC >, and ESC #)
is not valid for graphics or user-defined
characters.
ESC = (equal)
Set MSB to 0
Format:
ASCII code:
ESC
=
Decimal:
27 61
Hexadecimal:
1B 3D
Comments:
Sets the MSB of all incoming data to 0. Some computers always
send data with the MSB set to 1, which means that italics or
character graphics will always be printed. ESC = can overcome this
problem.
A-10
Command Summary