Filter
Top Products
The Interface Boards
#8143 new serial interface board
If you are using an optional interface, you may need to match the
communications protocol of the printer and the computer so they
can communicate properly. Use the information in your optional
interface manual or your computer’s manual to match the computer
with the interface.
For the #8143 optional interface board, use the DIP switch settings
shown below. These DIP switches are on the interface board, not
on the printer.
#8143 DIP switch settings
DIP SW
Function
1-1
Selects baud rate
ON
OFF
See following table.
1-2 Selects data length
7 bits
8 bits
I
1-3
1-4
Selects baud rate
Selects baud rate
See following
table.
See following table.
1-5 Selects EVEN ODD parity
EVEN ODD
1-6
Enables/disables parity check
Enabled
Disabled
1-7
Selects baud rate
See following table.
1-8 Enables/disables #8143 mode
Enabled Disabled
A-12
Appendix