Filter
Top Products
Installing the EpsonScript and LocalTalk boards
1.
Unpack the EpsonScript and LocalTalk boards.
Follow these guidelines when handling the EpsonScript
and LocalTalk boards:
Do not drop or bend.
Do not store in direct sunlight or near a heat source.
Make sure the printer is turned off when you insert or
remove the boards; otherwise, you can damage the
boards or the printer.
Do not touch the connectors. If the connectors become
dirty, clean them by wiping the edge with a clean
tissue. Do not use water, alcohol, or other solvents.
2.
Hold the EpsonScript board so its CN1 connector is face
down and position it over the CN3 connector on the
controller board.
3.
Insert the connector on the EpsonScript board into the
CN3
connector as shown below.
Setup 1-5