Filter
Top Products
Figure 3-3. Protective cover removed
5. Gently tilt the tractor unit toward you and push the tractor unit
down until you feel it lock into place.
Preparing the printer for pin-feed paper
With the tractor unit now installed, you can prepare the printer to
load the pin-feed paper. Follow the steps outlined below and refer to
Figure 3-5.
1. Set DIP switch
1-2
in the down position to enable the paper-out
detector. This allows the printer to stop printing and signal when
you are out of pin-feed paper.
2.Open
the paper bail by pulling it forward (toward the front of the
printer).
3. Unlock the gray pin-feeder lock levers on the tractor unit by pull-
ing them toward the front of the printer and slide both pin-feeders
outward to the sides. Open the black covers on the pin-feeders.
35