Filter
Top Products
Figure 3-7. Aligning pin frames
Note: Position wide paper
so that
the printable surface is between
1
and
136
on your paper bail (the holes will be outside of these
margins on the left and right).
5. Lock the pin-feeders in place by pushing the gray pin-feeder lock
levers back.
6. Confirm that the tractor pins are centered in the paper pin-holes
and that the paper tension is correct. If they are not, open the pin-
feeder covers, readjust the paper, and close them again.
7. Close the paper bail.
8. Set the print head adjustment lever according to the thickness of
your paper.
9.
Turn the paper feed knob clockwise to advance the paper until the
print head is positioned just under the first perforation which sep-
arates one page from another.
10.
Install the tractor unit dust cover.
11.
Turn the printer on. The ON LINE and READY lights should now
be on.
39