Filter
Top Products
Printer Operation Printer Operation
2-13 2-14
2.4 Status and Error Messages TEAR OFF PAPER
The following messages are displayed if a condition exists which prevents paper source and the fanfold paper could not retreat into the parking position.
normal operation of the printer. The operator must "tear off" the paper along the tear off edge which is located
LOCAL right). Press to enable the fanfold paper to be fed backwards to a park
Entered when [START/STOP] was pressed. The STOP indicator is lit. position so that the newly selected paper source can be used.
COVER OPEN REMOVE PAPER
Displayed when the top cover is open and the printer is in the READY or BUSY This message will be displayed if the output for cut sheets (Bin or Manual) is
mode. selected to FRONT SIDE/KEY. After printing and moving out at the front side
LOAD BIN paper and press .
Displayed whenever a form feed command or print command is given by the
host to an empty ASF cassette. The printer enters the STOP mode. Note: If there are error messages like AGC ERROR, HORIZ. DRIVE ERROR, or
LOAD TRACTOR service.
Displayed when the host sends a form feed or print command to an empty
tractor cassette. The printer enters the STOP mode.
LOAD MANUAL
Same as LOAD TRACTOR except that the machine does not enter the STOP
mode! Paper should be fed manually; after a short delay the printer will accept
paper and starts printing.
PAPER JAM TRF
PAPER JAM ASF
PAPER JAM MANUAL
Displayed if a form jams in the ASF or if successive line feeds fail to move
fanfold paper correctly when tractor feed is used. Please refer to chapter 5
Troubleshooting and Diagnostics for suggestions how to remove a paper
jam.
Displayed when a switch has been initiated from currently tractor to a different
directly above the fanfold paper output (paper should be torn off from left to
the printer enters the STOP mode and displays REMOVE PAPER. Remove
BUFFER OVERFLOW see Chapter 5.2 Error Messages, or call your