Filter
Top Products
CONFIDENTIAL
RP-U420 Mechanism control commands GS V
Ver. 1.0
p. 64
■ ■ ■
more
■ ■ ■
more
GS V
E
XECUTING
COMMAND
[Name]
Feed paper to the cutting position and cut it
[Format]
➀ ASCII GS V
m
Hex 1D 56
m
Decimal 29 86
m
➁ ASCII GS V
m
n
Hex 1D 56
m
n
Decimal 29 86
m
n
[Range]
➀ 0 ≤
m
≤ 2, 48 ≤
m
≤ 50
➁ 65 ≤
m
≤ 67, 0 ≤
n
≤ 255
[Default]
None
[Description]
Cuts a receipt.
• When DIP switch 1-7 is OFF (autocutter installed),
m
specifies the paper cutting operation as follows:
m
Printer Operation Mode
Standard Mode Taiwan Mode
0, 48, 1, 49 Cut (one point left uncut) Cut (one point left uncut)
2, 50 Cut (three points left uncut) Cut (three points left uncut)
65, 66 Feed receipt paper ((8 +
n
) × 4.23 mm),
then cut (one point left uncut).
If only receipt is selected as the printing sheet, feed
receipt paper to the preprint black mark position, then
cut (one point left uncut).
If both receipt and journal are selected as the printing
sheets, journal paper is also fed to the preprint black
mark position.
67 Feed receipt paper ((8 +
n
) × 4.23 mm),
then cut (three points left uncut).
If on ly receipt is selected as the printing sheet, feed
receipt paper to the preprint black mark position, then
cut (three points left uncut).
If both receipt and journal are selected as the printing
sheets, journal paper is also fed to the preprint black
mark position.
Mechanism control commands