Filter
Top Products
CONFIDENTIAL
RP-U420 Mechanism control commands GS V
Ver. 1.0
p. 65
• When DIP switch 1-7 is ON (manual cutter installed),
m
specifies the paper cutting operation as follows:
•
n
specifies the paper feeding amount before cutting a paper.
[Notes] ■ This command is effective only when processed at the beginning of a line.
■ This command is ignored when receipt is not selected as the printing sheet by ESC c 0.
[Notes for ➁] ■ In Taiwan mode, parameter
n
has no meaning.
■ For autocutter installed model, (8 × 4.23) mm is the optimal paper feed amount for cutting just under the
last printed line.
■ For manual cutter installed model, (10 × 4.23) mm is the optimal paper feed amount for cutting just under
the last printed line.
m
Printer Operation Mode
Standard Mode Taiwan Mode
0, 48, 1, 49 No operation No operation
2, 50 No operation No operation
65, 66 Only feed receipt paper
((10 +
n
) × 4.23 mm).
Only feed receipt paper to the preprint black mark position.
If both receipt and journal are selected as the printing sheets, journal
paper is also fed to the preprint black mark position.
67 Only feed receipt paper
((10 +
n
) × 4.23 mm).
Only feed receipt paper to the preprint black mark position.
If both receipt and journal are selected as the printing sheets, journal
paper is also fed to the preprint black mark position.
Program Example Print Sample
PRINT #1, CHR$(&H1B);"c0";CHR$(2); ← Select paper type
PRINT #1, " AAAAA"; CHR$(&HA);
PRINT #1, CHR$(&H1D);"V";CHR$(66);CHR$(0); ←
Feed paper and cut
Paper fed to the cutting position and
AAAAA
partial cut (one point left uncut)
performed