Filter
Top Products
140 EPSON S5U1C62000A MANUAL
(S1C60/62 FAMILY ASSEMBLER PACKAGE)
CHAPTER 9: DEBUGGER
9.7.4 Log File
The executed commands and the execution results can be saved to a file in text format that is called a "log
file". This file allows verification of the debug procedures and contents.
The contents displayed in the [Command] window are saved to this file.
Command example
>log tst.log
After the debugger is set to the log mode by the log command (after it starts outputting to a log file),
the log command toggles (output turned on in log mode ↔ output turned off in normal mode).
Therefore, you can output only the portions needed can be output to the log file.
Display of [Command] window in log mode
The contents displayed in the [Command] window during log mode differ from those appearing in
normal mode.
(1) When executing a command when each window is open
(When the window that displays the command execution result is opened)
Normal mode: The contents of the relevant display window are updated. The execution results are
not displayed in the [Command] window.
Log mode: The same contents as those displayed in the relevant window are also displayed in the
[Command] window. However, changes made to the relevant window by scrolling or
opening it are not reflected in the [Command] window.
(2) When executing a command while each window is closed
When the relevant display window is closed, the execution results are always displayed in the
[Command] window except for the program display commands (u, sc, m), regardless of whether
operation is in log mode or normal mode.
For the display format in the [Command] window, refer to each command description.