Filter
Top Products
Px Series Application Switch Installation and Configuration Guide 8-5
Using VRRP with the SummitPx1
on the backup. After all the commands have been replaced, the configuration is
saved and the box rebooted.
• Sends individual configuration commands from the master to the backup, where
they are stored in local memory until a
build command is issued on the master. The
backup then executes the stored commands in sequence and issues its own build.
The backup does not save the result. If you do not save it before the next boot, the
configuration is lost.
To determine if the configurations of the master and backup match, use the command:
show vrrp auto-sync
This displays the current state of synchronization. For example:
Auto-sync: Enabled
Master Partner IP: Not Configured N/A
Backup Partner IP: 10.65.4.250 Connected
------------------
MD5 (local config): c409f49b-911bca82-e5dc5fea-9cc0219c
MD5 (Master config):
MD5 (Backup config): c409f49b-911bca82-e5dc5fea-9cc0219c
The following commands can be passed from master to backup:
configure server
configure server-group
configure service
configure domain
configure pattern-rule
unconfigure server
unconfigure server-group
unconfigure service
unconfigure domain
unconfigure pattern-rule
build
Use the following commands to control the VRRP auto-sync facility:
enable vrrp auto-sync
disable vrrp auto-sync
show vrrp auto-sync
configure vrrp auto-sync forcesync
configure vrrp auto-sync backup partner-ip <ip>
configure vrrp auto-sync master partner-ip <ip>