Extron electronic 42-122-xx Network Card User Manual


 
Installation
AVTrac • Installation
15
Step 6: AAPs
At this point, the track, ramps and connectivitly box must all be securely in place, and the AC power module must be
attached to the connectivity box and connected to an AC junction box.
To attach the Architectural Adapter Plates (AAPs), follow these instructions:
6-1 Select up to seven AAPs to fill the remaining spaces
in the cover of the connectivity box.
In models without the AC power module, fill all ten spaces
of AAPs.
6-2 Use fish tape to run the cables from the connectivity
box through the wall or raceway to the appropriate
appliances (as described in section 5-3).
Attach the cables to the AAPs as described in the
installation guide for each AAP module and secure
the AAP to the cover of the connectivity box, using
the screws provided.
Test the power and signals to the AAPs.
Install AAPs
Run cable to AAPs
2.88" (7.30 cm)
2.50" (6.30 cm)
N
To prevent bending of cables, place the
AAP with the greatest depth requirement
(including cables) in the AAP slot closest to
the center ridge of the connectivity box.
End Plate
End Plate
Cover
Openings for
AAPs
AC Outlet
Cover Plate
RGB 580xi SI AAP
COMPUTER
AUDIO
H SHIFT
INPUT
SELECT
AAP
6-3 Reattach the end plates and cover panel.
End Plate
End Plate
Cover
AAPs
RGB 580xi SI AAP
COMPUTER
AUDIO
H SHIFT
INPUT
SELECT
N
Extron AAPs must be purchased separately.