Filter
Top Products
Before Getting Started,
cont’d
AVTrac • Before Getting Started
6
Almost everything you need to install your AVTrac system has been included. You will need some basic tools and
materials depending on the facility and requirements.
You can visit www.extron.com for a full range of cables and components for populating the connectivity box.
N
All structural steps and electrical installation should be performed by qualified personnel in accordance with
local and national building codes and/or local and national electrical codes.
Extron recommends the following equipment (not provided) to ensure the AVTrac is properly installed:
Tools:
Miter saw with blade for cutting metal
Handsaw for cutting drywall
Utility knives (box cutters)
Power drill
1/4" or 6 mm bit for drilling metal
Tin snips (metal shears)
Tools for terminating cables (if required)
Phillips head screw driver
Hex nut driver (1/4" and 5/16")
Equipment/other:
Tape measure
Marker pen
Level
Fish tape (used for pulling cables through cavity walls)
Cable ties
Vacuum cleaner
Carpet glue
Safety goggles
Tools and Equipment Required for Installation