Filter
Top Products
Setting Up the LAN Port
LAN Port Cabling
• For 10Base-T (10 Mbps) networks, use a Category 3 or better cable.
• For 100Base-T networks, use a Category 5 cable.
• Use a straight-through cable to connect to a switch, hub, or router.
• Use a crossover cable to connect directly to a PC. Wire the connector as shown in the
tables below.
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
A cable that is wired the same at both ends
is called a "straight-through" cable, because
no pin or pair assignments are swapped.
RJ-45
Connector
Insert Twisted
Pair Wires
12345678
Pins:
Crossover Cable Straight-through Cable
Pin
1
2
3
4
5
6
7
8
Wire Color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Wire Color
T568A
T568B
End 1 End 2 End 1 End 2
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Pin
1
2
3
4
5
6
7
8
Wire Color
Blue
White-blue
White-brown
Brown
Wire Color
T568B
T568B
White-orangeWhite-orange
OrangeOrange
White-greenWhite-green
Blue
White-blue
GreenGreen
White-brown
Brown
Figure 6. RJ-45 Connector Wiring
Configuring the LAN Port
You need to configure the LAN port before using it. You can configure the settings via either
SIS commands or the embedded web pages (see “HTML Configuration and Control” or
“SIS Programming and Control” for details).
LAN port factory defaults:
Link speed and duplex:
Auto Detect
Unit IP address:
192.168.254.254
Subnet Mask:
255.255.0.0
Gateway IP address:
0.0.0.0
DHCP:
Off
Connecting the Devices
Connect the cables to the rear panel as follows:
1. Plug the Ethernet cable from your network into the LAN port on the rear panel.
2. Plug the IPL T PCS4 power cord into a wall outlet. All front panel LEDs ash on briey;
only the power and Ethernet LEDs remain lit. (No receptacle lights should remain lit.)
NOTE: A label covers the power receptacle on the IPL T PCS4 (US version),
reminding you that you must use the supplied 14 AWG power cord for the
PCS4 to function properly. Remove this label before connecting the power
cord to the unit.
IPL T PCS4 • Installation and Rear Panel 6