Filter
Top Products
MLA-VC10 • Quick Start Guide
Setting Up the MLA-VC10
Quick Start Guide — MLA-VC10
To install and set up the MLA-VC10, follow these steps and see the
appropriate section of this manual for details:
Step 1
Determine the control voltage required
by the amplifier or mixer.
See “Determining the Control Voltage”
on pages 2-3 to 2-6 of this manual.
Step 2
Set the MLA-VC10’s DIP switches to match
the voltage determined in 1. See “Setting the
Configuration DIP Switches” on page 2-7, and
the reference tables on pages 2-8 and 2-9.
3
4
1
2
7
8
5
6
3
4
1
2
7
8
5
6
ON
CONFIGURATION
0 to 10.0VDC 0 to 4.98VDC NOT HALFWAY
UP
DOWN
CONFIGURATION
Step 3
Turn all of the equipment off. Make sure that the MediaLink
Controller (MLC) (if used), the MLA-VC10, the audio amplifier or
mixer, and RS-232 host device are turned off and disconnected from
the power source.
Step 4
Terminate cables and use them to connect the MLA-VC10 to the
MLC and/or a power supply and to an amplifier or mixer. See
“Cabling” on pages 2-9 to 2-11. Tie all grounds together.
MLA-VC10
Rear Panel
CTRL
1
2
3
4
5
6
ON
7
8
CONFIGURATION
AMP/MIXER
CONTROL
Amplifier
Rear Panel
REMT
VOL
MUTE
1
MUTE
2
GND
Ground ( )
0VDC to +10VDC
*
6 feet (1.8 m) maximum
between the MLA-VC10
and the amplifier
*
The actual maximum control voltage
depends on the Configuration DIP switch
settings, but the maximum power output will
not be reached if the amplifier's control port
voltage measures more than 10VDC.
QS-1
3
4
1
2
7
8
5
6
ON
CONFIGURATION
(Example)