Filter
Top Products
Remote power
The XTP HDMI transmitter and receiver can be powered remotely through an XTP Power
Injector or through an XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network
that uses XTP remote power should be routed outdoors.
Power injector
To power XTP HDMI transmitters and receivers remotely with an XTP Power Injector, power
one device locally (see Local power on page 11) and connect an XTP Power Injector to
the XTP cable run along the XTP ports (see the XTP Power Injector User Guide for more
installation information).
NOTE: The power injector provides remote power up to 330 feet with a CATx cable with
24 AWG wire.
POWER
12V
HDMI
--A MAX
R
x
G
Tx
RS-232 IR
RxTx
−+ −+
L
R
LOOP-THRU
RESET
AUDIO
OFF
ON
AUDIO
LAN
SIG LINK
XTP OUT
INPUTS
OVER XTP
LAN
ACT LINK
SIG LINK
XTP OUT
POWER
12V
HDMI
--A MAX
Rx
GTx
RS-232 IR
RL
RxTx
-+ -+
1
2
AUDIO
OFF
ON
AUDIO
S/PDIF
RESET
LAN
SIG LINK
XTP IN
OVER XTP
OUTPUTS
RELAYS
ACT LINK
SIG LINK
XTP IN
XTP
PWR
XTP PWR
100-240V
50/60 Hz
---A MAX
Extron
XTP T HDMI
XTP Transmitter
Extron
XTP R HDMI
XTP Receiver
Extron
XTP PI 100
XTP Power
Injector
CATx Cable
Remote
Power
HDMI
HDMI
Display
Blu-Ray
Player
12 V Local Power
Supply
Figure 11. Typical Point-to-Point Application with Remote Power
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power
to connected XTP endpoints (refer to the user guide of the XTP matrix switcher for more
details). To manage available power from the XTP matrix switcher, use the XTP System
Configuration Software (see XTP System Configuration Software on page 23).
XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 12