Filter
Top Products
Calibrating the system
35
To start the calibration procedure
● Put the 565 into standby by pressing the Off key.
● Press and hold the front panel Off key for at least five
seconds.
The display shows:
Calibration
After a few seconds the display
shows:
Levels
followed by:
Left +0dB
Levels is the name of the first calibration test. For more detailed
information about this and the other calibration tests see the
following sections.
To exit from the calibration procedure
You can exit from the calibration procedure at any time, and any
parameters you have set will be retained.
● Press Off on the front panel or Meridian System Remote.
To move between the calibration tests
● Press Store on the front panel or Meridian System Remote.
The calibration tests are described in the following sections.