Filter
Top Products
RAID Controller Configuration
4-7
Select Terminal (VT100) mode if following the instructions above and press e. This will
display the screen shown in Figure 4-11.
In the example shown the physical configuration consists of a single tower with 6 disk drives.
The first task is to create a RAID set which is a logical drive as far as the host is concerned.
This logical drive will appear as a normal disk to the Operating System and will behave
similar to any other disk with the added benefits of enhanced reliability and performance.
Prior to creating the RAID set, verify that the configuration as seen by the RAID controller
Figure 4-10 Initial Screen
Figure 4-11 Main Menu Screen