Filter
Top Products
D2630 (RX600 S3) SAS 23
Features Replacing the RAID Controller
V Caution!
Back up your data before you change your system configuration, to
ensure no loss of data.
Perform the following steps to install the new RAID™ SAS controller:
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove
it from the antistatic bag and inspect it for damage.
If the controller appears to be damaged, contact FSC support
service.
Step 2 Prepare the Computer
Turn off the computer and unplug the power cord(s) from the
back of the power supply. Remove the cover from the chassis.
V Caution!
Make sure the computer is disconnected from the power
and from any networks before removing the controller.
Step 3 Review the Jumpers and Connectors
The following figure shows the location of the jumpers and
connectors on the RAID SAS controller. The jumpers are set at
the factory and you usually do not need to change them.
table 2 describes the jumpers and connectors on the controller.
U13
J10
J12 J18
J6
J5
J9
J7
U11
J11
J15
J1
J3
J4