Filter
Top Products
D2630 (RX600 S3) SAS 27
Features Replacing the RAID Controller
Step 6 Power-Up the Computer
Replace the computer cover and reconnect the power cord(s).
Turn on the computer. Ensure that the SAS and/or SATA II
devices are powered up before or at the same time as the host
computer. If the host computer is powered up before the SAS or
SATA II devices, the devices might not be recognized.
During boot, a MegaRAID BIOS message similar to the
following displays:
LSI MEGARAID BIOS VERSION xxxx [date] Copyright(c)
2005, LSI Logic Corporation HA-1 (Bus x Dev y)
MegaRAID SAS 8408E PCI-Express RAID Controller
Standard FW xxxx DRAM=xxx MB(SDRAM)
Step 7 Run the WebBIOS Configuration Utility
Run the WebBIOS Configuration Utility to configure the physical
arrays and logical drives. When the message Press
<Ctrl><H> for WebBIOS displays on the screen, press
CTRL+H immediately to run the utility.
Step 8 Install the Operating System Driver
The SAS 8408E can operate under various operating systems.
To operate under these operating systems, you must install
software drivers.
The ServerSupport CD includes drivers for the supported
operating systems, along with documentation. You can view the
supported operating systems and download the latest drivers
for RAID adapters on the web site at:
http://service.fujitsu-siemens.com