Filter
Top Products
SETTING UP
2-22 User's Manual
NOTE
The LAN interface is a user add-on option.
When installing a LAN card, remove the two screws securing the cover
and remove the cover. Then insert the LAN card and reattach the cover
with the two screws removed earlier. For details, refer to the Online
Manual that comes with the LAN card.
4. To secure a parallel interface cable, flip the fastener clips located on
the printer into the notches on the cable connector. To secure a serial
interface cable, tighten the screws in the cable connector.
5. Attach the other end of the interface cable to your computer.
Gently pull on the cable to verify that it is secure.
6. Close the shutter.
Centronics parallel Centronics parallel + USB (+LAN)Centronics parallel + RS-232C
Connecting the interface cable
3. Attach the interface cable to the connector.
Do not connect more than
one interface cable type to the printer at the same time.
To reattach the shutter, tilt the shutter and insert one of its convex parts
into the installation hole of the printer, and then insert the other part in
the other hole. After inserting both convex parts, lower and push the
shutter in to its original position.