Filter
Top Products
AP-2
Appendix2 DAILY CARE
■ Cleaning Materials
*1: For details about the cleaning materials, contact the
FUJITSU scanner dealer where you purchased the
scanner.
*2: Pre-moistened with Cleaner F1, Cleaning Wipes are
used instead of moistened cloths.
■ Cleaning Method
The ADF must be cleaned with a lint-free cloth moistened
with the Cleaner F1.
■ Locations and Cycle for Cleaning
For details on cleaning the ADF, refer to section 4.3 "Clean-
ing the ADF" of "fi-6140/fi-6240 Operator’s Guide" on the
Setup CD-ROM.
When operating the scanner, the ADF’s inside glass
becomes very hot.
Before you clean inside the scanner, turn off its power
and unplug the AC adapter from the outlet. Wait for at
least 15 minutes.
Turn on the scanner when you clean the Feed rollers
or Eject rollers.
Cleaning
Materials
Parts
Number
Remarks
Cleaner F1 PA03950-
0352
1 bottle
Moisten the cloth with
this fluid and wipe the
scanner clean. (*1)
Cleaning wipe PA03950-
0419
24 sheets per pack
(*1)(*2)
Lint-free dry cloth - Commercially available one
ATTENTION
It may take long before the cleaner vaporizes if a large
quantity is used. When cleaning the scanner parts,
dampen a cloth with modest quantities of the cleaner. In
addition, wipe off the cleaner completely with a soft lint-
free cloth to leave no residue on the surface of the
cleaned parts.
Part to clean Standard Cleaning Cycle
Brake Roller Clean these parts after every 5,000
sheets.
Pick roller
Feed rollers
Plastic rollers
Eject rollers
Glass
ATTENTION
The scanner must be cleaned more frequently if you scan
any of the following type of sheets:
• Documents of coated paper
• Documents that are almost completely covered with
printed text or graphics
• Chemically treated documents such as carbonless paper
• Documents containing a large amount of calcium
carbonate
• Documents written by pencil
• Documents on which the toner is not fused sufficiently.