Filter
Top Products
C141-E134-01EN 5 - 5
5.3 Setting Terminals
A user sets up the following terminals and SCSI terminating resistor before installing the IDD in
the system as required.
• Setting terminal: CN2 (MP model only)
Figures 5.2 shows the setting terminal position. Figures 5.3 shows the allocation and default
settings.
CAUTION
Data loss
1. The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2. Do not change the setting of terminals except following setting pins
during the power is turned on.
• Write protect: CN2 9-10 (MP model only)
3. To short the setting terminal, use the short plug attached when the device
is shipped from the factory.
Figure 5.2 IDD setting terminals position (MP model only)
CN2
Pin 1