Filter
Top Products
40
LifeBook P7000 Notebook – Section Four
Figure 4-6 Inserting/Removing PC Cards
PC Cards
Your Fujitsu LifeBook notebook supports Type I and II
PC Cards, which can perform a variety of functions.
Some available PC Cards:
■
Local area network (LAN) cards
■
SATA II cards
■
Gigabit Ethernet cards
■
IEEE1394 cards
■
IEEE802.11n cards
For further information, refer to the instructions
supplied with your PC Card.
INSERTING PC CARDS
PC Cards are inserted in the PC Card slot. To insert a
PC Card, follow these easy steps: (Figure 4-6)
1. See your PC Card manual for specific instructions
on the insertion of your card. Some PC Cards may
require your notebook to be Off while inserting
them.
2. Make sure there is no PC Card currently in the slot.
If there is, see Removing PC Cards.
3. Insert your PC Card into the slot, with the product
label facing up.
4. Push the card into the slot firmly until it is seated
in the opening. You will hear a click and the Eject
button will pop away from your notebook.
REMOVING PC CARDS
To remove a PC Card, follow these easy steps:
1. See your PC Card manual for specific instructions
on removing your card. Some PC Cards may require
your notebook to be in Standby Mode or Off while
removing them.
2. Push the PC Card eject button to the right. This will
push the PC Card slightly out of the slot allowing
you to remove the card.
PC Card Slot
PC Card Eject Button
■
Installing or removing a PC Card during
your LifeBook notebook’s shutdown or
bootup process may damage the card
and/or your notebook.
■
Do not insert a PC Card into a slot if
there is water or any other substance on
the card as you may permanently dam-
age the card, your LifeBook notebook,
or both.
When you receive your system, there may
be a PC Card plug installed in the slot. This
is designed to keep unwanted material out
of the slot. Before installing a PC Card, be
sure to remove the plug with the same
procedure as outlined in “Removing PC
Cards”. Use the plug when a PC Card is
not installed.
Windows has a shutdown procedure for
PC Cards that must be followed before
removing a card. (Please review your oper-
ating system manual for the correct proce-
dure).
If the dialog box states that the device
cannot be removed, you must save all of
your open files, close any open applica-
tions and shut down your notebook.
If the PC Card has an external connector
and cable, do not pull the cable when
removing the card.
B5FJ-4181-01EN-01.book Page 40 Wednesday, August 22, 2007 9:04 AM