Filter
Top Products
TX300 S6 Options Guide 41
6 Processors
V CAUTION!
● Before installing/removing processors to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also
unplug all power cords from the power outlet. Failure to do so can
cause electric shock.
● Do not touch the circuitry on boards and soldered parts. Hold the
metallic areas or the edge of the circuit boards.
● When adding a processor, be sure to add memory into "DIMM 1D"
additionally. Refer to chapter "Main memory" on page 37 for the
installation of the memory.
● When installing the processor, be careful not to bend the pins of the
processor socket.
● Follow the safety instructions in the chapter "Safety instructions" on
page 19.
V CAUTION!
Processors are modules which can react extremely sensitively to
electrostatic discharges and which must therefore always be handled
with care. After a processor has been removed from its protective sleeve
or from its socket, place it with its smooth side down on a non-
conducting, antistatic surface. Never push a processor over a surface.