Filter
Top Products
58 Options Guide TX300 S6
Accessible 5.25-inch drive Accessible drives and LSD/LSP
7.2.2 Installing an accessible 5.25-inch drive
Figure 28: Attaching the EasyClick rails - example: DVD drive
Ê Screw the EasyClick rails onto either side of the new 5.25-inch drive using
two M3x4.5mm screws.
Use the first hole in each lower row of holes as shown in the figure.
I Keep the remaining screws for future use. The different drives are
fastened using different screws.
Please use the screws which are provided with the packaging
contents of the tape drive.
Ê Push the new drive about halfway into the bay.
Ê Connect the data cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Push the drive fully into the bay until the EasyClick rails lock in place.
Ê Attach the front cover or the rack front cover as described in the section
"Attaching the front cover" on page 108 or in the section "Attaching the rack
front cover" on page 111.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 105.