Filter
Top Products
A
P-1
APPENDIX
Modification for Switching from
Landscape to Portrait Orientation
To use the MU-150C for portrait with the CH-37, FCV-1200 series, FCV-1500 series or
FR-1760DS, the LCD assembly must be turned 180°.
1. Place the display unit on a workbench with the LCD side down. It is recommended to
place the unit on cushioning material so as not to place pressure on knob.
2. Unfasten the items marked with white arrows in the figure below to remove the cover for
the power section and connectors: 10 screws, four spacers for connectors and two nuts
of waterproof connectors. This gives access to the CONE Board (10P6877) and power
assy.
Display unit, rear view
3. Remove the 14 screws marked with gray arrows in the figure above.