Filter
Top Products
5-12
5.9 Scanning
Radio equipment scans a group of operator-selected frequencies
(channels), and stops scanning when an incoming signal is received.
1. Press function key [F3] and then the [5] key. The Scanning
Group List appears on the screen.
You can confirm the scan channel by [↑] key or [↓] key while
pressing the [Shift] key.
*1
2
*3
Scanning Group List
Figure 5-12 Scanning group list
2. Select a scan group and press the [Enter] key.
3. The scanning starts and the indication "Scan" appears in in-
verse video on the communication status display. (The name
of the scan group appears at the "Station Name".)
Station Name : SAITO-1 Print Scan T.Op HT Scra
Frequency (T/R) : 8344.00 / 8705.00(kHz) Comm Mode : CW
Comm Status : Connect Send Lock Error
Sending Volume : 100(%) ARQ Error : 0 ARQ Time : 0(sec)
1996-11-15 02:01 (JST)
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
Figure 5-13 Communication status display
4. To stop scanning, press function key [F3] and then the [5] key.
5.10 Communication Buffer
The communication buffer is a temporal memory which stores trans-
mitting messages or receiving messages. To display the contents
of the comunication buffer;
1. Escape from the communication display.
2. Press the [PgDn] or [PgUp] key. The contens of the communi-
cation buffer are displayed.
To print them, press [Ctrl] and [P] keys simultaneously. To erase
them from the screen, press [PgDn] key again.