Filter
Top Products
Magnum 6K16V Managed Fiber Switch Installation and User Guide (06/04)
all of these, and is available now.
Magnum 6K16V Managed Fiber Switches have heavy duty metal cases and
auto-ranging power supplies for operation with standard AC power worldwide. Internal
DC power supplies are optional. All DC power input types (5V, 24V, 48V, 125V) are
supported, and dual source input is optional on all except 5VDC..
There are two Alarm Relay contacts provided on each Magnum 6K16V
Switch to monitor basic operations.. One is for hardware, and will signal loss of power
internally. The other is software controllable and will signal user-defined software events
such as a security violation or an S-Ring fault condition.
The wide variety of port modules are key to the flexibility and adaptability.
2.2.1 Eight-port SFF fiber modules (6K8-MTRJ, 6K8-MLC), 100Mb fiber
Fig.2.2.2 :
SFF Fiber Port
Modules,
6K8-MTRJ (to the left)
and
6K8-MLC or -SLC
(below)
In an eight-port SFF
fiber port module, all of the fiber
ports are of the same speed
(100Mb), mode, and connector
type. Models are available with
Small Form Factor (SFF) are
multi-mode MT-RJ or LC-type connectors, and single-mode LC-type connectors.
1 3 5 7
2 4 6 8
LK LK LK LK
ACT
F/H
ACT
F/H
ACT
F/H
ACT
F/H
LK LK LK LK
ACT
F/H
ACT
F/H
ACT
F/H
ACT
F/H
2 4 6 8
LK LK LK LK
ACT
F/H
ACT
F/H
ACT
F/H
ACT
F/H
2 4 6 8
LK LK LK LK
ACT
F/H
ACT
F/H
ACT
F/H
ACT
F/H
1 3 5 7
The 100Mb fiber eight-port modules for the Magnum 6K16V’s normally are
set (factory default) to operate in full-duplex mode for best fiber distance and
performance. Using the 6K16V’s MNS software, the user may select full- or half-duplex
mode per-port through set-up of the software (See Magnum 6K16V MNS Software
Manual) for the flexibility to adapt to any FDX or HDX type of Fast Ethernet devices).
There are three LED’s per fiber port. The Link (LK) LED indicates “ready for
8
www GarrettCom com
..