Filter
Top Products
Magnum 6K16V Managed Fiber Switch Installation and User Guide (06/04)
2.2.4 Four-Port 10 Mb
and 100Mb mm Fiber ST Modules
The 4-port @10Mb ST fiber modules behave the same as the 4@100Mb ST
fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are
present, ports 3, 4. 7, 8 are not present. There is also a similar 100Mb fiber SC module.
The default setup on the 10Mb fiber module is half-duplex, which allows the
Magnum 6K16V Switch to connect to any 10Mb hub or media converter or almost any
other device with a 10Mb fiber Ethernet port. The default setting of the 100Mb module is
full duplex. User mode-control per port through the MNS “port settings” software is the
same as the other 6K16V modules.
The fiber ports support fiber cabling distances according to the 10BASE-FL
and 100BASE-FX standards, i.e., 2km distance for multi-mode fiber. (Single-mode for
up to greater distance may be available as a special order, request quote).
2.2.6 Gigabit (1000Mbps) port modules
The Magnum 6K16V offered a wide option Gigabit speed with multiple choice
for the modular slot. While up to two Gigabit modules (maxm.) can be configured in the
modular slot. The Gigabit port option for the modular slot comes in couple of different
configuration. The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45),
whereas the single Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2
(100Mb fiber ports) as shown below in the figure.
1@ 1000Mb Fiber SC + 2@ 100Mb SC 1@ 1000Mb Fiber SC + 4@10/ 100Mb
The 6K16V Modules provide a GBIC opening for insertion of industry-standard GBICs
to provide Gigabit (Gb) media flexibility. GBIC models are available for both multi-
mode (550m) and single-mode (10, 25,40,70)km fiber options, and for Gigabit copper as
well, with new models appearing often.
2 6TX RXL
ACT
F/
TX LK RX
ACT
F/
TX RXLK
ACT
F/
1 3 5 7
10/100
L
F/
ACT
TX R XLK
ACT
F/
2 6
T LK
R
ACT
HF/
TX RX
LK
AC
H
T
F/
ACT
HF/
TX RXLK
ACT
H
1 5
F/
TX R XLK
11
www GarrettCom com
..